Aquamax EM50 Series Bedienungsanleitung

This water heater must be installed and serviced by a qualified person. Please leave this guide with the householder. Owner’s Guide and Installat

9 Major Five (5) Year Service It is recommended a major five (5) year service be conducted on the water heater. Servicing must be performed b

10 Warning: Exercise care when operating easing lever as water discharged from the water heater may be of a very high temperature. War

11 The life of the storage cylinder may be extended by arranging a qualified person to periodically inspect the anode and replace

12 water supply TDS exceeds 600 mg/Litre, the magnesium alloy anode (supplied as standard, cap colour code ‘Black’) should be replaced w

13 Water Chemistry Levels Affecting Warranty The Aquamax warranty of this water heater will not cover resultant faults on components including t

14 Troubleshooting Check the items below before making a service call. If the water heater is within/out of the warranty period you will be

15 Pressure Temperature Relief Valve Running • Normal Operation It is normal and desirable for the PTR valve to allow a small quantity of water

16 • Is one outlet (especially the shower) using more hot water than you think? Refer to “Not Enough Hot Water” on page 14. • Is there

17 water supply in the event that this water heater was to become inoperable for any reason. We recommend you provide advice to the syste

18 Water Supplies Mains Water Supply Where the mains water supply pressure exceeds that shown in the table below, an approved pressure

1 Warning: Upon completion of the installation and commissioning of the water heater, leave this guide with the householder or responsible office

19 correctly inserted or aligned, it should be gently pushed back into place before connecting any plumbing fittings. Warning: Plastic liner

20 Left & Right Hand Side Water Connections – EM50 Models All Aquamax mains pressure electric water heaters are manufactured with dual inlets

21 Pressure Temperature Relief Valve (PTR valve) The PTR valve must be fitted before the water heater is operated. Before fitting the PTR valv

22 If a drain line discharges into a tundish, the drain line from the tundish must be not less than DN20. The drain line from a tundish must meet t

23 Two Temperature Zones Using a Temperature Limiting Device This water heater can deliver water at temperatures which can cause scaldin

24 Circulated Hot Water Flow & Return Systems For circulated hot water flow and return systems, a temperature limiting device can on

25 Electrical & Electrical Connections Warning: The power supply to the water heater must not be switched on until the water heater i

26 power supply will provide the maximum financial savings. Discuss the power supply requirements with the householder. Connect the power

27 1. Switch off electrical supply to the water heater. This can be performed at the switchboard or water heaters isolating switch if one i

28 3. Close each hot water tap after all air is purged (when air is purged water will run freely without air bubbles or spluttering).

2 CONTENTS Householder: Read the section “About Your Water Heater” (pages 3 to 16). The “Installation” section is intended for the

29 Dimensions & Technical Data E80 ~ E400Models Model E80 E125 E160 E160X E250 E315 E400 Hot Water Delivery (L) 80 125 160 160 2

30 EM50 Models Hot Water Delivery (L) 50 Connections Weight Empty (kg) 23 Cold water inlet RP¾/20 Power lead & plug Refer to diagram Hot wat

31 WARRANTY AQUAMAX ELECTRIC DOMESTIC MAINS PRESSURE WATER STORAGE HEATER WARRANTY – AUSTRALIA ONLY- 1. THE AQUAMAX WARRANTY - GENERAL 1.1 T

32 2.4 Where the water heater is installed outside the boundaries of a metropolitan area as defined by Aquamax or further than 2

33 2.8 Subject to any statutory provisions to the contrary, this warranty excludes any and all claims for damage to furniture, c

34 4. ENTITLEMENT TO CLAIM UNDER THIS WARRANTY 4.1 To be entitled to make a claim under this warranty, you need to: a. Be the owner of the water

35 INSTALLER INFORMATION DEAR INSTALLER, Please provide the following information upon completion of the installation. This information should be

3 ABOUT YOUR WATER HEATER Product Application This water heater is designed for use in a single family domestic dwelling for the purpose of

4 Single Element Model This type of water heater has one heating unit with its own thermostat. The heating unit is at the base of the wa

5 Mains Pressure Operation This water heater is designed to operate at mains pressure by connecting directly to the mains water supply. If the mai

6 To minimise scalding, especially for those people in high scald risk categories i.e. young children, people with potentially inc

7 Warning: The thermostat and its protective over temperature cut out are mounted inside the front cover(s) of the water heater. The

8 How Long Will the Water Heater Last The water heater is supported by a manufacturer’s warranty (refer to page 31). There are a number of factors